System information

Upgrading Your System
1-14 AlphaServer 1000 to 1000A Upgrade
Replacing the Top Cover and Side Panel
Follow these steps and refer to Figure 9 to replace the top cover and side panel of
the system unit:
1. Align the guides on the top and bottom inside of the side panel with the lip of
the system unit frame.
2. Tilt the side panel top towards the unit and lift the flange at the top of the panel
over the system unit frame.
3. Slide the panel forward into position.
4. Align the top cover with the top of the side panels and slide the cover gently
onto the unit from the rear (5). Hold down the top cover release latch (4) until
the top cover is in place, and then release it to secure the cover and panels.
5. Lock the top cover and side panels using the system unit key.
6. Remove the power cord from the AlphaServer 1000 and install it on the
AlphaServer 1000A system.
7. Plug the power cord into the wall outlet.
8. Set the On/Off switches on all external options connected to the system to the
"on" position.
9. Set the On/Off switch on the system unit to the "on" position.
Figure 9 Replacing the Top Cover and Side Panels
MA00281
4
2
1
5
3
1 Bottom side
panel guide
2 Top side
panel guide
3 Right side
panel
4 Top cover
release latch
5 Top cover