Specifications

6-28 • Configuring AlphaServer 1000A Owner's Guide
5. A jumper cable (17-04021-01) connects the 68-pin connectors (J11 and J16) in
the center of the backplane. This connection unites the upper four and the
bottom three drives to the bus.
6. The bus is terminated by an active internal SCSI terminator (12-45490-01) at
the 68-pin connector (J10) on the backplane. See Figure 6-7.
7. Jumper W1 in the J3 set of jumper pins on the backplane is installed, and the W2
and W3 jumpers are removed.
Figure 6-6 SCSI Cable Termination
Optional
SCSI
Ports
SCSI
Terminator
MA00945