Specifications

5-26 • Installing and Removing Components AlphaServer 1000A Owner's Guide
Removing the Power Supply
To remove a power supply, refer to Figure 5-16 and follow these steps:
1. If an optional power supply is installed, you must remove it before removing the
primary power supply.
2. Disconnect all internal and external cables from the power supply.
3. Loosen the four screws that secure the power supply to the outside rear of the
unit.
4. Loosen the two screws that secure the internal end of the power supply to the
system unit.
5. Slide the power supply towards the internal side and lift it up off its tabs.
Figure 5-16 Removing the Power Supply
MA00920
Rear Screws
6/32 Inch (4)
Internal Screws
3.5 mm (2)
Power Supply
Cable
Connections