Specifications

5-22 • Installing and Removing Components AlphaServer 1000A Owner's Guide
3. Insert the hard disk drive into the guide slots and push the drive in until its tabs
lock in place.
4. Check the configuration of the drive. See the section "Determining SCSI Storage
Device IDs" in Chapter 6, "Configuring" for more information.
Figure 5-13 Installing a StorageWorks Disk Drive
MA00240
Removing a StorageWorks Disk Drive
To remove StorageWorks disk drives, reverse all steps in the installation procedure.
Installing a Diskette Drive
To replace a 3½-inch diskette drive, refer to Figure 5-14 and follow these steps:
1. Remove the original diskette drive.
2. Locate the ID select switch toward the rear on the righthand side of the
replacement diskette drive. Set the switch to the 1 position.
3. Slide the diskette assembly into the front of the bay until the screw holes line up
with the holes on the bracket.
4. Attach the mounting bracket to the replacement diskette drive using the two
screws that you removed from the original diskette drive.
5. Connect the power cable and the data cable to the diskette drive.