Instruction manual

Using the SRM Console
2-2 AlphaServer 1000/1000A Supplement
AlphaServer 1000A Systems
The AlphaServer 1000A
show config
command display (Example 2-1)
includes these elements:
Firmware:
Version numbers for the firmware code, PALcode, SROM chip, and
CPU are displayed.
Memory:
Size and configuration for each bank of memory are displayed.
Hose 0, Bus 0, PCI:
All controllers on Hose 0, Bus 0 of the primary PCI bus are
displayed. For storage controllers, the associated devices are also displayed.
Slot 7 is assigned to the PCI-to-EISA bridge chip
Slot 8 is assigned to the PCI-to-PCI bridge chip
Slots 11-13 correspond to physical PCI option slots on the primary PCI bus:
Slot 11 = PCI 11
Slot 12 = PCI 12
Slot 13 = PCI 13
Note:
If the system finds PCI devices it does not recognize, the
device and vendor ID will appear as 0000 1011 in the
show config
display. This does not mean that the device is not supported, only
that it is not in the SRM table of known devices.
Hose 0, Bus 1, EISA:
All controllers on Hose 0, Bus 1 of the EISA bus are
displayed. The logical slot numbers in the left column of the display correspond
to physical EISA option slots (1 and 2). For storage controllers, the associated
devices are also displayed.
Hose 0, Bus 2, PCI:
All controllers on Hose 0, Bus 2 of the secondary PCI bus are
displayed. The logical slot numbers are listed in the left column of the display.
For storage controllers, the associated devices are also displayed.
Slot 0 corresponds to the SCSI controller on the system board,
along with storage drives on the bus.
Slots 1-4 correspond to physical PCI option slots on the
secondary PCI bus:
Slot 1 = PCI 1
Slot 2 = PCI 2
Slot 3 = PCI 3
Slot 4 = PCI 4
Hose 0, Bus 3, PCI:
If PCI options contain a PCI-to-PCI bridge, such as the
DECchip 21050-AA in the secondary PCI bus (slot
4 in Example 2-1),
the additional bus is represented in the display. For each option that