User`s guide
5.1.4 Verifying Configuration: SRM Console Commands for DEC
OSF/1 and OpenVMS
The following SRM console commands are used to verify system configuration on
DEC OSF/1 and OpenVMS systems:
•
show config
(Section 5.1.4.1)—Displays the buses on the system and the
devices found on those buses.
•
show device
(Section 5.1.4.2)—Displays the devices and controllers in the
system.
•
show memory
(Section 5.1.4.3)—Displays main memory configuration.
•
set
and
show
(Section 5.1.4.4)—Set and display environment variable settings.
5.1.4.1 show config
The
show config
command displays all devices found on the system bus, PCI
bus, and EISA bus. You can use the information in the display to identify target
devices for commands such as
boot
and
test
, as well as to verify that the system
sees all the devices that are installed.
The configuration display includes the following:
• Firmware:
The version numbers for the firmware code, PALcode, SROM chip, and
CPU are displayed.
• Memory:
The memory size and configuration for each bank of memory is displayed.
• PCI Bus:
– Slot 6 = SCSI controller on motherboard, along with storage drives on the
bus.
– Slot 7 = EISA to PCI bridge chip
– Slots 11–13 = Correspond to PCI card cage slots: PCI0, PCI1, and PCI2.
For storage controllers, the devices off the controller are also displayed.
• EISA Bus:
Slot numbers correspond to EISA card cage slots (1–8). For storage
controllers, the devices off the controller are also displayed.
For more information on device names, refer to Figure 5–2.
System Configuration and Setup 5–9