User`s guide

Using a VGA Controller Other than the Standard On-Board VGA
When the system is configured to use a PCI- or EISA-based VGA controller
instead of the standard on-board VGA (CIRRUS), consider the following:
• The on-board CIRRUS VGA options must be set to disabled through the ECU.
• The VGA jumper (J27) on the upper-left corner of the motherboard must then
be set to disable (off).
• The console environment variable should be set to graphics.
• If there are multiple VGA controllers, the system will direct console output to
the first controller it finds.
5–38 System Configuration and Setup