User's Manual

15
ASSEMBLING SPINDLE ATTACHMENTS
CAUTION!
Do not leave threaded accessories on the spindle of the tool for extended periods of time,
as this may result in making it diffi cult to remove these accessories.
Note: The Alpha
®
High-Speed Angle Grinder has a 5/8”-11 spindle thread . It comes with
two Inside Flange and Locking Flange sets: 20mm Arbor for 4” discs and 7/8” Arbor
for 4-1/2” to 5” discs.
To attach an approved spindle attachment to the tool, follow the steps below:
CAUTION!
Always disconnect the plug from the electrical outlet before carrying out any work on the
machine.
Mount the inside fl ange. (use the
20mm Inside Flange and Locking
Flange Set for 4” discs or the 7/8”
Inside Flange and Locking Flange Set
for 4-1/2”-5” discs).
Add the working tool and then the locking fl ange as shown in Figure 10 and 11.
1.
2.
Figure-9
Figure-11Figure-10
Cutting Wheel in photo is not included.