Installation User guide

3.0 Connection Instructions, continued

745-419-C4-001Rev.A(09/2009)

The XM2 batteries are isolated from chassis ground by design. Any voltage potential difference between battery

(-)andchassisgroundmustbeeliminatedbeforeinstallingthetranspondertoavoidpotentialtransponder

damage.Toaccomplishthis,attachagroundjumperbetweenbattery(-)andchassisgroundbeforeinstallingthe

transponder. Once the transponder is installed the jumper may be removed if desired.

WARNING!

3.3 XM Series 2 Power Supply

Switch Battery Breaker OFF prior to removing the Inverter Module for USM2/USM2.5 Card installation and

conguration.

When connecting to an XM Series 2 power supply, plug the 13-pin

connector so the black wire is in pin1 and two open pins are left at

the top for tamper switch connection.

XM SerieS 2 Power SuPPly ConneCtion note:

Pin 1

Tamper switch

connector

Legend

RF Cable

2, 3 Battery Sense Wire Kit for: 36V single string, 6', Alpha p/n 874-842-21

36V single string, 9', Alpha p/n 874-842-27

36V dual string, 6', Alpha p/n 874-842-20

36V dual string, 9', Alpha p/n 874-842-28

48V single string, 6', Alpha p/n 874-841-21

48V single string, 9' Alpha p/n 874-841-25

48V dual string, 6', Alpha p/n 874-841-20

48V dual string, 9', Alpha p/n 874-841-24

XM Series 2 Power Supply

Interface Cable

Alpha p/n 875-335-20 (USM2/2.5)

XM Series Power Supply

Interface Cable

Alpha p/n: 875-335-21 (USM)

AM Series Power Supply

Interface Cable

Alpha p/n: 875-335-21 (RPM)

5 Battery Heater Mat Control Cable Alpha p/n 875-627-20

6 Ethernet Cable (optional) Customer supplied

7 RTS Cable (optional) Alpha p/n 745-178-21

8 Vin Sense (optional) Alpha p/n 875-493-21

9 Surge Protector Ground Block Alpha p/n 162-028-10

Plug-in Lightning Arrestor w/pass thru

(130V) L-G, L-N, N-G

Alpha p/n 162-046-10

Figure 4, Connections between the transponder and the system