User manual

IPDP - installation and operating instructions
10
The flat cable connection is facilitated by connector
locks, preventing from rotation, but to keep the
connection routing is imperative.
“To IP DoorPhone” is always the routing to the basic
module.
“To NCmod” is
routing to the row
end (on last
NC-mod.).
Picture 6 IPNC4-mod module
1.3.3 IPDP-K Keyboard Module
The keyboard module is only connected by flat cable as
well as NC-mod4 module. The only difference is that
keyboard module is always the last in row (no other
module can be connected behind it). Connect on the first place (to output of the
IPNCx-mod) or the second (to output of the first NC-mod4) positions or third
place. It means that 4 to 24 buttons with direct dialing can be used instead of
keyboard (per assembly). The most frequent used assemblies are:
IPDP-00 + IPNCx-mod + IPDP-K
IPDP-00 + IPNCx-mod + NM-mod4 + IPDP-K
IPDP-00 + IPNCx-mod + NM-mod4 + NC-mo4 + IPDP-K
IPDP-00 + IPNCx-mod + NM-mod4 + NC-mod4 + NM-mod4 + IPDP-K
Pay attention when programming – the position of keyboard connected must be
correctly specified.
The choice is entered by gradual
pressing of buttons with digits. Firstly
the key symbol must be pressed to
enter a password. When pressing X,
the DoorPhone will hang up or cancel
your dial. Button with key symbol use
for “Point” in IP adress in P2P mode.