Service manual

34 BRAVE Steel – User and service manual
Note. If you want to keep a connection opened during the programming (prolong the 30
sec time) regime (i.e. before a customer decides what else he wants to be set) then you
can press * or #, the Brave immediately answers with an error tone but will prolong the
time before disconnecting.
4.2 Programming with the help of a PC – programme
BraveSet
To programme the Brave with the PC you will; need to use the special
cable USB-KAB and programme BraveSet. The Brave will also need to be
connected to a telephone line, or with version (C) switched on and connected
to an internal power supply 12V - DIP3 and 4.
Procedure:
- Connect the Brave Steel to the line or with version (C) it is possible to use
external power supply 12V (DIP 3,4);
- Connect Brave Steel to the PC via the USB cable. The Brave will pick up a
line and within 3 seconds a tone for programming entry will be heard (see
chapter 3.1 Page.27).
- Run programme BraveSet. Until the USB is disconnected the Brave is
connected to the PC and is in programming regime and will not run any
other operations. If you lose connection, you will need to reconnect the
USB cable – the Brave will then pick up.
- Connection between the Brave and the programme is indicated by the
firmware on the bottom edge and a time on the upper left (C), if you have
version (LC) then the time is nil as the reduced version does not have a
RTC circuit.
For ease of orientation the parameters in the BraveSet programme are
marked with the same codes as per the phone programming.
The details about parameter setting can be found in „help‟ of the
programme and also on the manufacturer‟s website www.alphatech.cz.