User guide

BRAVE – user guide

3.2 Visitor at the door

Door intercom buttons have signs (cards) like usual ring buttons. Visitor

find desired name (for example“Scott") and push it. The Brave intercom pick up

the line and "play" tone line pick up (when is not switch off by par.62) and dial

phone number saved under the button (parametr 1 or 2 up door intercom mode).

From Brave intercom speaker you hear ringing tone and phone of Mr. Scott is

ringing. As soon as Mr. Scott pick up ringing phone he can talk to visitor at the

door. When is electrical lock connected to Brave intercom then Mr. Scott can

open the door for visitor by dial DTMF code on his phone. When Mr. Scott hang

up the phone then Brave intercom hangs up as well after busy tone detection.

When call duration is longer then setup limit (parametr 52) the 10sec before

hang up Brave intercom sends alerting tone of call ending. Mr. Scott can dial *

or # up setting (parametr 42) to prolong the call about the time setup by

parametr 52.

Dialled number from Brave intercom is different up dial mode setup in the

unit by (parametr 47):

- Day/Night mode = when intercom is in DAY mode then number setup by

parametru 1 is dialled. When intercom is in NIGHT mode then always dial

number setup by parametr 2. Manual intercom modes switching is setup

by parametres 45,46. In version (C) you can switch DAY/NIGHT mode

automatically. Selection of dialled number saved under the button is control

by time up table (parametry 00-06).

- 2 groups numbers mode = first button push – always dial number setup

by parametr 1. When the same button is pushed or 10seconds after dial

busy tone is detected, or setup number of rings is out (parametr 56) the

door intercom dial number from second group setup by (parametr 2). When

you push the same button again you will dial again number from first group

etc.……(when after dial number from second group busy tone is detected

the repeating is finished)

When visitor push the button after line is picked up the door intercom

hangs up for time setup by parametr 54 and then picks up the line and dial new

number ( second push number). The number dialling is either by tone dial

(DTMF) or pulse dial up setting by parametr 41. There is one more option and it

is line hangs up by again pushing of same button (parametr 4*).

You can control relay(s) by door intercom buttons (code lock). When

visitor push buttons in order which match to setup code (parametr 32-34) and

time between each button press is not longer than setup by (parametr 53) then

door intercom picks up and activate appropriate relay (when relay setup is mode

m=1 or m=5) for time setup by parametr 37 eventually.39,30. Then hangs up.

The relay (up control code) can activate one pulse or two pulses with time

between each pulse setup by parametr 30 via. Tab. 1.