User Manual

29745-419-C0-002, Rev. B

4.0 Using the Local Port

Local Port Connection Procedure:

1. Connect the RS-232 to logic level converter (Alpha P/N 875-349-10) to the computer and

the transponder.

2. Setup computer to use Hyper-Terminal. Settings are: 19200 baud, 8, N, and 1.

3. Press ENTER to view the display.

4. Press ? to display the menu:

HELP - This help

? - This help

RESET - Reset transponder

STATUS - Transponder conﬁ g and status

ALARMS - Display active alarms

ID - Enter logical ID

PSDATA - Display power supply data

DEVICE - Display device status

PSTEST - Initiate power supply test

GENDATA - Display generator data

GENTEST - Initiate generator test

GENRESET - Reset generator alarms

5. Verify using menu item PSDATA1 that communications between the power supply,

communication card, and the transponder is established and reliable. Verify valid data

is displayed for the addressed power supply.

6. Verify using menu item STATUS that the transponder version data is consistent and

record the address:

MAC Address: 00-10-3F-00-00-0D

Serial No: E1E8E7

Version: 1.0.2.L 1600 950-0315 A 05.00

IP Address: 192.168.1.102

Check code: 0x0000

CommonNEStatus: 0x19

(actual data will be different)

NOTE:

To access additional conﬁ guration options type “gubed” at the command prompt, followed by password

“THEBEST”.