Installation and Operation Manual Owner manual
28
745-020-B0-003, Rev. C
3.0 Installation, continued
3.2 Lifting Procedure
The enclosure is lifted via four lifting plates included with the generator. The lifting plates are
attached to the cabinet with 1/4-20 x 3/8" stainless steel SAE J429 Grade 8 hex-head bolts,
torqued between 80 and 90 in-lbs.
To prevent injury or death, do not walk, or allow personnel to walk, beneath the suspended
unit. Use steel-toe work shoe protection. Use hard hats at all times during this procedure.
Before lifting, verify the transport path is clear of obstructions.
Fig. 3-3, Lifting Plates Attached to Cabinet
24" min. Spreader Bars
Front View Side View
WARNING!