Installation and Operation Manual Owner manual

26
745-020-B0-003, Rev. C
3.0 Installation
Prior to installation verify the following:
All necessary grounding rods and materials are in place.
Utility power was run to site in accordance with the NESC (National Electric Safety Code).
Obtained local safety practices for working with high-voltage systems.
Gas piping, hardware, supports, and other gas carrying components to the pad location conform
to NFPA standard and local requirements.
Required Tools and Materials:
Crane to lift enclosure from shipping pallet and place on pad
Key(s) to enclosure doors
• Digital voltmeter
Torque wrench with insulated handle and 7/16" socket
7/16” box-end wrench
NO-OX or other suitable corrosion inhibiting agent (NCP-2)
Silicone sealant GE RTV123 (or equivalent)
Phillips screwdriver (for pad shear mounting)
5/8" socket for removing pallet mounting bolts
• Hard hats
• Utility knife
MOUNTING STUD POSITION
O
0.625 x 1.000 4 PL
ENCLOSURE
FRONT
26.00
O
0.875GROUND SWEEP
O
3.000DC SWEEP
O
1.375AC SWEEP
0.25
3.00
5.35
5.60
7.60
0.581
3.40
Fig. 3-1, Sweep Dimensions (in inches)