Manual

3. Maintenance
46
031-132-B0-001 Rev. A
TM
©2000
3.7 Replacing Ignition Battery Charger Module Assembly
End of Procedure
Allow 15 minutes for completion of procedure
Tools required: #2 Phillips screwdriver
Removal and replacement procedure:
1. Locate and remove the charger module as shown below.
The charger module is located on the
outside of the APU housing, above the
generator run/stop switch mounting
bracket. Disconnect the connectors
from the front of the module.
Use the #2 Phillips screwdriver to
remove the two mounting screws from
the inside of the APU housing.
Slide the module out and replace with
new charger unit.