Instruction manual

26
INNER BELT INSTALLATION
1. Install new belt by rotating and pushing outward onto the pulleys as shown in
Figure 36.
2. The belt pulley system is self-centering; rotate belt and pulleys together for a few
revolutions by hand.
CAUTION!
Beltscannotbetesteduntilinnerandouterangesandangeboltareinstalledtoholdthe
pulleyrmlyinplace,(otherwise,beltandpulleywillyoffofthespindle.)
.
3. Reinstall belt cover and secure with phillips screw.
4. Replacesidecoverbycarefullypushingitintoplaceandsecurewiththevephillips
screws.
5. Gently tighten side cover screws to a snug condition, to
prevent screw tabs on side cover from breaking off, as shown
in Figure 37.
6. Reinstallinnerandouterangesandangebolttoholdthe
pulleyrmlyinplace,otherwisebeltandpulleywillyoffof
spindle
Figure-37
Figure-36