User's Manual

equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating
instructions for satisfying RF exposure compliance.
IEEE 802.11b or 802.11g operation of this product in the U.S.A. is
firmware-limited to channels 1 through 11.
Antennas must be installed to provide 20 cm separation distance from the
transmitting antenna to the body of the user during normal operating condition.
This device must not be co-located or operating in conjunction with any other
antenna or transmitter.
Only those antennas filed under FCC ID: RRKWUSN10A1 can be used with
this device.
When the module is installed in the final system where the antenna location is
less than 20 cm separation distance to the body of user, additional equipment
authorization must be applied.
FCC ID label on the final system must be labeled with “Contains FCC ID:
RRKWUSN10A1” or “Contains transmitter module FCC ID: RRKWUSN10A1”.
In the user guide, final system integrator must be ensure that there is no
instruction provided in the user guide to install or remove the transmitter
module.
The transmitter module must be installed and used in strict accordance with the
manufacturer's instructions as described in the user documentation that comes
with the product. This device complies with the following radio frequency and
safety standards.