User's Manual

the antenna used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.
(b) Manual must include tested maximum compliance eirp power as documented in
the manual and FCC filling for each supplied antenna.
(c) Warning to the installer that final eirp radiated power must adjusted to lower or
equal to tested maximum eirp as documented in the manual.
If the end product integrating this module is going to be operated in 5.15 ~
5.25GHz frequency range, the user’s manual of end product must include
following statement:
“The 5.15~5.25GHz frequency band in US/Canada is restricted to indoor use
only.”
Industry Canada Statement
Operation is subject to the following two conditions:
1) this device may not cause interference and
2) this device must accept any interference, including interference that may
cause undesired operation of the device
This device has been designed to operate with an antenna having a maximum
gain of 18 dBi.
Antenna having a higher gain is strictly prohibited per regulations of Industry
Canada. The required antenna
impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its
gain should be so chosen that the EIRP is not more than required for
successful communication.