User's Manual

in public retail store is prohibited.
2) Professional installer must carefully consult the professional installation
manual and program the conducted output power no more than tested maximum
conducted power for each antenna as documented in the manual
3) The antenna of end product must be installed so that at least 20 cm is
maintained between the antenna and users, and
4) The transmitter module may not be co-located with any other transmitter
or antenna.
5) The module must be completely embedded inside the final product
and there is no direct access from outside to remove the module without
opening the product chases with a tool.
6) OEM shall not display or instruct the user how to install or remove
the module.
As long as 6 conditions above are met, a further transmitter test will not be required.
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed (for example,
digital device emissions, PC peripheral requirements, etc.).
End Product Labeling
The final end product must be labeled in a visible area with the following: “Contains
TX FCC ID: RRKWMPD18”.
Manual Information
The OEM integrator has to be aware not to provide information to the end
user regarding how to install or remove this RF module in the users manual of
the end product which integrate this module.
The users manual for OEM integrators must include the following information
in a prominent location
(a) RF exposure warning as below:
IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements,