User Manual

Modular Approval
This device is intended only form OEM integrator under the following conditions:
1) The antenna must be installed such that 20cm is maintained between the antenna and users, and
2) The transmitter module may not be co-located with any other transmitter or antenna.
IMPORTANT NOTE: In the event that these conditions cannot be met (for example certain laptop
configurations or co-location with another transmitter), then the FCC authorization is no longer considered
valid and the FCC ID cannot be used on the final product. In these circumstances, the OEM integrator will
be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC
authorization.
End Product Labeling
This transmitter module is authorized only for use in devices where the antenna may be installed such that
20 cm may be maintained between the antenna and users (for example access points, routers, wireless
ADSL modems, and similar equipment).
End Product Manual Information
The user manual for end users must include the following information in a prominent location “IMPORTANT
NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter
must be installed to provide a separation distance of at least 20cm from all persons and must not be
co-located or operating in conjunction with any other antenna or transmitter.”
1.0 Scope
1.1 Document
This document is to specify the product requirements for 802.11b/g Mini-PCI Module. This
Mini-PCI Module is based on Ralink RT2560 chipset that complied with IEEE 802.11b standard
from 2.4~2.5GHz, and it can be used to provide up to 11Mbps for IEEE 802.11b and
54Mbps/108Mbps for 2.4GHz IEEE 802.11g to connect your wireless LAN.