User's Manual

AP200 Wireless Access Point Quick Installation Guide
4
The LED indicator on the front panel of the access
point should come on.
Software Connection
The default IP address of the access point is
192.168.0.50 with a subnet mask of 255.255.255.0.
By default, the username is admin and there is no
password.
Connect to the Web User Interface
On the management PC, open any standard web
browser software, like Internet Explorer and in the
address bar enter the IP address of the access point.
Press the Enter key the keyboard.
The login window will appear as shown below:
Enter the username and password, in the spaces
provided, and click the Login button to access the
Web UI.
For more information about the Web User Interface
configuration, refer to the AP200 User Guide.
Other Software Connections
This access point can be managed by the WiFi
Controller software, greatly enhancing
manageability and wireless frequency optimization
as well as providing additional user management
and security options. For more information about
the WiFi Controller software, refer to the AP200 User
Guide.
Safety Instructions
The following sections provide safety precautions to
follow when installing the access point.
Safety Precautions
For your protection, observe the following safety
precautions when setting up your equipment:
• Follow all cautions and instructions marked on the
equipment.
• Only trained and qualified personnel are allowed to
install or to replace this equipment.
• Never push objects of any kind through openings in
the equipment. Dangerous voltages may be present.
Conductive foreign objects could produce a short
circuit that could cause fire, electric shock, or damage
to your equipment.
• This product is intended for restricted access whereby
access is controlled through the use of a means of
security (for example, key, lock, tool, badge access) and
personnel authorized for access have been instructed
on the reasons for the restrictions and any precautions
that need to be taken.
• Remove all metal jewelry, such as rings and watches,
before installing or removing the device.
• Do not install in direct sunlight, or a damp or dusty
place.
• Do not expose the device to moisture or water.
• Disconnect all power supply cords before servicing.
Electrical Safety Precautions
For your protection, observe the following electrical
safety precautions when setting up your equipment:
• Ensure that the voltage and frequency of your power
source match the voltage and frequency inscribed on
the equipment’s electrical rating label.
• Not all power cords have the same current ratings. Do
not use the power cord provided with your equipment
for any other products or use. Household extension
cords do not have overload protection and are not
meant for use with this product. Do not use household
extension cords with this product.
• To prevent electric shock, do not remove the cover of
this product. There are no user-serviceable parts inside.
This unit contains hazardous voltages and should only
be opened by a trained and qualified technician.
• Do not work on equipment or cables during periods of
lightning activity.
• Check to see if there are any exposed copper strands
coming from the installed wire. When this installation is
done correctly there should be no exposed copper wire
strands extending from the terminal block. Any
exposed wiring can conduct harmful levels of electricity
to persons touching the wires.
• When using the power supply, the power source for the
device should be located near the unit and should be
easily accessible.