User Manual

Industry Canada Statement

This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the

following two conditions:

1) this device may not cause interference and

2) this device must accept any interference, including interference that may cause undesired

operation of the device

This device has been designed to operate with an antenna having a maximum gain of 4.74

dBi.

Antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The

required antenna

impedance is 50 ohms.

To reduce potential radio interference to other users, the antenna type and its gain should be

so chosen that the EIRP is not more than required for successful communication.

IMPORTANT NOTE:

IC Radiation Exposure Statement:

This equipment complies with IC radiation exposure limits set forth for an uncontrolled

environment. End users must follow the specific operating instructions for satisfying RF

exposure compliance. To maintain compliance with IC RF exposure compliance requirements,

please follow operation instruction as documented in this manual.

以下警語適用台灣地區:

經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大

功率或變更原設計之特性及功能。

低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，

並改善至無干擾時方得繼續使用。前項合法通信，指依電信法規定作業之無線電通信。低功率射

頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。

本模組於取得認證後將依規定於模組本體標示審驗合格標籤，並要求平台上標示「本產品內含射

頻模組：ID 編號」