User's Manual

IEEE 802.11g Cardbus Wireless Network Adapter

Option Tab

Under General Setting, check “Auto launch when Windows starts up” so

that WLAN automatically launches when Windows starts up. Check “Use IP

Setting in Profile” to enable the IP settings made under IP Config in the

Wireless Network Properties screen. If checked current IP settings will be

saved. If unchecked (and previously checked), previous IP settings will be

restored. If “Use Windows IP settings” is checked, IP settings from “Network

and Dial-up connections” will be used. Check “Disable Radio” to disconnect

the network connection without removing the WLAN cardbus card.

Under Advanced Settings, check “Enable Turbo Mode” to enable turbo

mode. Turbo mode can then take effect if you are using a turbo mode

enabled Access Point. Set the Encryption Type to Auto, WEP, or Advanced

Encryption Standard (AES). The Radio Frequency has been preset to

802.11g-2.4GHz.

Note: Currently, the Turbo Mode is only available in the United States.