User's Manual

12
To complete the installation, please follow these steps:
1. Connect the Router/Gateway to a Broadband connection (e.g., a
Cable modem or a DSL modem.)
2. Connect the 802.11g Access Point to the router.
3. Install the 802.11g USB Adapter into a laptop or desktop computer
on your wireless network
4. Check the Device Manager to confirm that the wireless adapter is
installed correctly. Please refer to the Networking Basics section in
this manual entitled: Checking the Installation of the Drivers for the
Wireless Adapter.
5. By default, the wireless adapter is set to obtain a Dynamic IP
Address. If you are having difficulty connecting, check to make sure
that the IP Address of the wireless adapter is within the IP address
range of your network. Please refer to the Networking Basics
section in this manual entitled: Checking the IP Address.