Owner`s manual

17
ASP (Audio Signal Processing) Settings
Enter the ASP setup program menu by touching ASP.
The ASP Settings menu allows you to make fine audio adjustments.
ASP settings have four sub-menu settings: Bass, Treble, Subwoofer
crossover frequency and Bass Q factor. See picture below:
Bass Frequency:
Touch Bass Freq to open adjust screen
60Hz, 80Hz, 100Hz,200Hz adjustment points Depending on the audio source,
select the Bass Center Frequency to achieve the best Bass effect.
Treble Frequency:
Touch Treble Freq to open adjust screen
10KHz,12.5KHz,15KHz,17.5KHz adjustment points Depending on the audio
source, select the Treble Center Frequency to achieve the best Treble effect.
Sub Filter:
Touch Sub Filter to open adjust screen
80HZ, 120HZ, 160HZ adjustment points. Selecting a crossover frequency sets
a cut-off frequency of the subwoofers LPF (low-pass filter). This adjustment is
only available when using the subwoofer line level output. It will not effect any
speakers connected to the internal amplifiers in the unit.
Bass Q-Factor:
Touch Bass Q-Factor to open adjust screen
When the Bass Center Frequency is selected, adjusting the Bass Q-Factor
alters the sharpness of the Bass output
To exit the A.S.P. Settings menu, press the home icon in the upper left
corner of the LCD display