Owner`s manual

Steering Wheel Function Study

Enter the System Settings program menu by touching SYSTEM. Select Wheel

Study This menu allows you or your installer to program the internal Steering

Wheel Control interface in this unit to enable the steering wheel controls in

your vehicle’s steering wheel (if you have this option from the factory) to

control main functions of this unit. PLEASE SEE NOTE BELOW. The steering

wheel function study interface is shown in the picture below:

To program the Steering Wheel Interface for basic steering wheel control:

1. Press Wheel Study, and the Study menu will appear

2. Press Mode 1

3. Then press one of the steering wheel control buttons on your vehicle’s

steering wheel

4. Press the corresponding icon in the Wheel Study menu. The icon will

darken to confirm the command.

5. Continue the above procedure until all buttons on your steering wheel are

programmed into the Wheel Study menu

6. Exit the Wheel Study menu by pressing the home icon

NOTE: Some vehicles will require you to program your steering wheel controls

to the unit by using both Mode 1 and Mode 2. Please see your Alpha-Nav

dealer for more information. If this is required, program Mode 1 as above, and

then press Mode 2 and follow the same programming steps you did in Mode

1. When you are done, exit the Wheel Study menu, and programming is

complete

NOTE: The internal Steering Wheel Control interface in this unit may not be

able to interface with your vehicle’s steering wheel controls. Please check with

your Alpha-Nav dealer to check for compatability.

Your dealer should complete the following programming steps for you.