Instruction manual

Page 46 Chapter Eight
Eagle 450 Upgrade Instructions, Rev. A00
4. If present, unplug the AM-968 Front Panel Display Adapter. Unplug all cables and wires
attached to it. You’ll later reattach the ribbon cable and these wire pairs: red/white, yellow/white,
green/white, and green/black. The other wire pairs will not be needed in the Eagle 450.
5. Remove the two screws attaching the AM-135’s mounting plate to the chassis, as shown in
Figure 8-3.
POWER SUPPLY
1
2
3
4
5
6
MAIN ELECTRONICS BOARD
MOUNTING BRACKET
To remove the board mounting
assembly, you must remove
these two screws.
Figure 8-3: AM-135 Mounting Bracket Removal
6. Carefully lift the mounting plate up and forward, toward the front of the chassis, then out.
The mounting plate helps to stabilize the chassis. With it removed, You will be able to rock
the chassis back and forth slightly. This is normal.
6. Remove the AM-135 from the mounting plate by unscrewing the nine screws holding it in place.