Instruction manual

Eagle 100 Upgrade: Hardware Installation Page 27
Eagle 450 Upgrade Instructions, Rev. A00
110
REMOVE THESE
FIVE REAR PANEL
SCREWS
REMOVE THE TWO SCREWS
HOLDING THE SCSI CONNECTOR
TO THE REAR PANEL
SCSI
MAIN
ALT
BOOT
A1 A2
B1 B2
C1 C2
D1 D2
F1 F2
G1 G2
H1 H2
PARALLEL 1PARALLEL 0
ETHERNET
E1 E2
Figure 6-3: Removing the Old Rear Panel
2. Attach the new Eagle 450 rear panel (DWF-20753-08) to the back of the chassis using the five
screws you just removed. Leave the screws loose for now.
3. Reinstall the CPU mounting plate, which now has the AM-138 attached. First slide the connector
end of the AM-138 into place in the rear panel. Then, move the other end into the proper
orientation and press down over the small locating bumps in the chassis bottom. You may have
to rock the chassis top slightly forward or back to lock the locating bumps in place, with the
mounting plate flush against the chassis bottom. Once the plate is placed properly, install its two
mounting screws.