Service manual

Page 22 Eagle Series Computer Service Manual
DSS-10517-00, Rev. B01
Eagle 550 Rear Panel Screws
Refer to the following steps and illustration to unfasten the main electronics board from the “Super
Eagle” (Eagle 550) rear panel.
1. Remove the three Phillips-head screws where indicated in the illustration. The three screws hold
the AM-319(-20) I/O mounting bracket to the chassis rear panel.
2. Next, remove the threaded hex nut where indicated, to provide enough clearance to lift the AM-
319(-20) board up and out of the chassis bottom pan.
115
SCSI
1
0
PRINT PORT 0
PRINT PORT 1
PRINT PORT 2
PRINT PORT 3
ABC D E F G
SIO EXPANSION BUS
TX RX LINK AUI 10 base T UPS SERIAL PORTS
3
2
1
0
Remove these
screws to
unfasten the
AM-319(-20)
board from the
rear panel.
Remove this hex nut
to provide enough
clearance to lift the
AM-319-20 board up
and out of the chassis.
Eagle 550 Rear Panel Screw Locations