Owner`s manual

Page 8-3Status Display Codes
Front Panel Status Codes - All Eagle Systems (continued)
CODE MEANING
x4 The computer is reading the Master File Directory (MFD) from disk. An
error at this point indicates disk problems.
x5 Searching for the User File Directory (UFD) account [1,2] on the boot
device.
x6 Searching for BADBLK.SYS. Valid only on disk drives that use a
BADBLK.SYS file.
x7 Loading BADBLK.SYS. Valid only on disk drives that use a BADBLK.SYS
file.
x8 The computer is searching for account DSK0:[1,4]. An error at this point
may indicate disk problems. Try reloading the latest version of the system
software.
x9 The computer is looking for the system monitor file in DSK0:[1,4]. If this file
is missing, reload the latest version of the system software.
x9 If your computer is trying to boot from a tape device, this code indicates
the computer is searching for a label block on the tape.
xA The computer is loading the AMOS monitor from the boot device. This
code might indicate a disk problem.
xb The computer is beginning to execute the AMOS monitor program. If an
error occurs at this point, try reloading the latest version of the system
software.
xd Computer bootup failed because of a time-out error. This code may
indicate faulty memory or an addressing problem.
2E Computer bootup failed because of a bootstrap loader program checksum
error. This code may indicate a bad PROM or bad memory.
xF Computer bootup failed because of an invalid boot device selection. Check
the boot ID switches on the back panel of your computer, or the Eagle 550
CMOS setup parameters. See Chapter 2 for proper settings.
Eagle Series Computer Owner’s Manual, Rev. 03