Owner`s manual

Page 7-3Troubleshooting Procedures
Procedure #1: Check Power/Run/Memory Lights
A.Are the power light and fan on? If yes, go to Step B. If the fan is on but the power
light isn’t, your power light may be burnt out. Go to Step B.
1.Press the power button to turn the computer off.
Make sure the power cord is not damaged and is the correct type for your
geographical area. Make sure it is plugged in firmly on both ends. If there is
a problem with the cord, correct it and go to "Procedure #3:
Powerup/Reset." If the computer comes up correctly, your problem is fixed.
2.Check the electrical source by plugging something else into the outlet, such
as a lamp. If there is a problem with the outlet, correct it and go to
"Procedure #3: Powerup/Reset." If the computer comes up correctly, your
problem is fixed.
3.Check to make sure your computer is configured for the proper input voltage
by checking to see the voltage setting is correct on the voltage switch on the
back panel of your computer.
Caution: If you have operated the computer with the improper input
voltage, you may have damaged the computer.
If your computer is configured incorrectly, change the voltage switch to the
proper setting, and perform "Procedure #3: Powerup/Reset" only ONCE. If
the computer does not come up correctly, shut off the power and contact
your VAR for help; stop. If it does, your problem is fixed.
If your computer is configured correctly, proceed:
4.If the voltage configuration is correct, and the power cord is OK and in place
correctly, but the power light is still not on, call your VAR for help. Stop.
B.OK, the power light is on. Is the run light on? If so, skip to Step C.
1.If the run light is off, then perform "Procedure #2: Check the System Status
Codes." If the procedure does not find and correct any problems, proceed.
2.Perform "Procedure #3: Powerup/Reset," ONCE. If that procedure does not
correct the problem, proceed.
3.Perform "Procedure #5: Self Test." Call your VAR with the results of your
self test and ask for help. Stop.
C.The power light and the run light are both on. Check the front panel display, after
booting successfully the status LED will display a 0 and the run light should be on.
If a status code appears on the front panel display and the computer does not
boot, compare the status code with the status codes shown in Procedure #2.
Eagle Series Computer Owner’s Manual, Rev. 03