Owner`s manual

Page 5-14 Chapter Five
DSKANA DSK1:
RETURN
[Begin analysis of DSK1:]
[1,2]
.
[100,20]
[The following blocks were marked in use but not in a file]
1767 1772 2562 3456 6265
[The following blocks were in a file but not marked in use]
[Rewriting BITMAP]
No file errors
If you see the "No file errors" message, the file structure on the disk is intact. If DSKANA
lists a number of file errors, there is a problem with the disk’s file structure. Your next
step is to run DSKANA again, using either the /L or /E option—discussed below—to see
where the errors are on the disk.
For the complete procedure to follow if DSKANA finds any file errors, see "Recovering
From Disk Errors" in the
System Operator’s Guide .
DSKANA Options
DSKANA has several options, allowing you to select exactly what information you want
to see. Your choices are:
OPTION FUNCTION
None Displays account numbers on disk and summary only.
/C Same information as default, but does not rewrite bitmap.
/E Lists files and blocks in which any errors occur.
/L Lists all files and blocks on the disk.
To use one of these options, place it after the DSKANA command like this:
DSKANA DSK1:/C
RETURN
As mentioned above, you need to use the /L or /E option to find the location of any file
errors DSKANA detects. The /C option is discussed in the next section.
To see the list of DSKANA options, type DSKANA
RETURN
without specifying a device name.
Eagle Series Computer Owner’s Manual, Rev. 03