Owner`s manual
Page 3-10 Chapter Three
Only insert a diskette into the drive when the computer is turned on—likewise, do
not leave a diskette in the drive when you turn off the computer. Turning the
computer on and off can cause power spikes that can damage the data on your
diskette.
Whenever you insert a diskette, be sure to use the MOUNT command (discussed
below) to tell your computer a new diskette is in the drive.
Never change diskettes if the drive is busy; doing so could damage the data on
the diskettes. There is a small light on the front of the disk drive that is lit if the
drive is busy.
When you remove a diskette from the drive, store it in its envelope and place it in
a box where it is protected from dust.
MAC205
Inserting a 51/4" Diskette
AUTOSHUTTER
MICRO FLOPPY DISK
3-1/2"
HIGH
DENSITY
MAC204
Inserting a 31/2" Diskette
Eagle Series Computer Owner’s Manual, Rev. 03