Instruction manual

Troubleshooting Page 5-3
Eagle 450 Installation and Technical Manual, Rev. 00
Front Panel
Status Code
Description
9 Memory parity error was encountered.
F During booting, memory is being cleared and sized.
10 An interface driver (.IDV) defined in a TRMDEF statement in the system
initialization file was not found in account [1,6] on first logical of the boot
device.
11 A terminal driver (.TDV) defined in a TRMDEF statement in the system
initialization file was not found in account [1,6] on the boot device.
12 AMOS system initialization (.INI) file not found in account [1,4] on the first
logical of the boot device.
20 The computer is beginning to execute the boot PROM. An error at this point
indicates your computer has a faulty PROM. Contact your VAR.
21 The computer is transferring the instructions from the PROM into its
Random Access Memory (RAM). If an error occurs here, the computer
might have a bad PROM or bad memory.
22 The computer is generating a checksum of the instructions in Random
Access Memory. If this calculated checksum does not match the checksum
coded into the instructions themselves, you see a 2E error code. If an error
occurs here, the computer might have a bad PROM or bad memory.
24 Reading the Master File Directory (MFD) from disk. An error at this point
indicates disk problems in the alternate boot device.
25 Searching for the User File Directory (UFD) for account [1,2] on the first
logical of the alternate boot device.
28 Searching for account [1,4] on the first logical of the alternate boot device.
An error at this point may indicate disk problems. Reload the latest version
of the system software.
29 If you are
booting from a tape device
, the computer is searching for a label
block on the tape, as the alternate boot device.
2A Loading the AMOS monitor from the alternate boot device. If an error
occurs at this point, reload the latest version of the system software.
2b Beginning to execute the AMOS monitor program from the alternate boot
device. If an error occurs at this point, reload the latest version of the system
software.
2d Bootup from the alternate boot device failed because of a time-out error.
This may indicate a faulty memory or an addressing problem.
2E Bootup from the alternate boot device failed because of a bootstrap loader
program checksum error. This may indicate a bad PROM or bad memory.