Instruction manual

Configuration Page 3-9
Eagle 450 Installation and Technical Manual, Rev. 00
• PDB-00359-50
—For configurations where the Eagle 450 ports are replacing an AM-355. The kit
includes eight PRA-00243-04 cable assemblies. Each assembly has a four-foot parallel patch
cord with an RJ-45 connector at one end and a modular female DB9 connector at the opposite
end. You simply plug the RJ-45 connector into the Eagle 450 and the female DB9 into the male
DB9 connector previously plugged into the AM-355 board.
• PDB-00359-51
—Connects the Eagle 450 ports to an existing six-wire patch panel using a three-
pair wiring system. The cable assembly has eight RJ-45 connectors with six wires each, which
plug into the two AM-90 boards attached to Eagle 450 ports. The opposite end of the cable
assembly is a female RJ-21 connector which plugs into your six-wire patch panel.
This cabling kit (PDB-00359-51) does not support DCD for modems, but it does support
DTR.
• PDB-00359-52
—Connects the Eagle 450 ports to an eight-wire patch panel using a four-pair
wiring system. The cable assembly has six RJ-45 connectors with eight wires each, which plug
into six Eagle 450 RJ-45 connectors. The opposite end of the cable assembly is a female RJ-21
connector which plugs into your eight-wire patch panel. This kit also includes two of the four-
foot long RJ-45 to female DB9 connectors used in the PDB-00359-50 cabling kit, for the two
ports not plugged into the patch panel.
• PDB-00359-53
—Four RJ-45 to male DB25 adapters for connecting modems to the Eagle 450.
This kit requires a shielded parallel patch cord with RJ-45 connectors at each end, like the 10-
foot PRA-00189-10 cable in the PDB-00359-56 cabling kit described below.
• PDB-00359-54
—Four modular RJ-45 to male DB25 adapters for connecting printers and
terminals to the Eagle 450 ports. This kit requires a shielded parallel patch cord with RJ-45
connectors at each end, like the 10-foot PRA-00189-10 cable supplied in the PDB-00359-56
cabling kit described below.
• PDB-00359-55
—Four modular RJ-45 to female DB9 adapters for connecting a PC-AT style
serial port to an Eagle 450 port. This kit requires a shielded parallel patch cord with RJ-45
connectors at each end, like the 10-foot PRA-00189-10 cable supplied in the PDB-00359-56
cabling kit described below.
• PDB-00359-56
—This kit includes four (PRA-00189-10) 10 foot shielded parallel patch cords
with RJ-45 connectors at each end.
The following illustrations contain signal and pinout information for each of the PDB-00359-5x cabling
kits: