Instruction manual

Installation Instructions: Roadrunner 030/040 Eagle Upgrade Page 11
PDI-03500-00, Rev. B01
X-Bus Cabling Instructions
Two 34-pin cables create a data path between the AM-319 board and your Roadrunner board. The
illustration below shows how the cables are connected between the various AM-319 and Roadrunner
board combinations. All cable connections must be made pin-1 to pin-1.
The top two diagrams show connections for
Rev. C00 and later
AM-319-00 boards. On earlier
versions of the boards, while the cables connected to the same physical locations, the labels on
the board were reversed.
DWB-00319-00 TO DWB-00172-00 X-BUS CABLING
AM-319
AM-172
J5
J6
J5
J6
C/S
A/D
A/D
C/S
DWB-00319-00 TO DWB-00174-00 AND -02 X-BUS CABLING
AM-319
AM-174-XX
J5
J6
J2
J3
C/S
A/D
C/S
A/D
DWB-00319-20 TO DWB-00174-00 AND -02 X-BUS CABLING
AM-174-XX
AM-319-20
P7
P8
J2
J3
C/S
A/D
C/S
A/D
(for Rev. C00 and later of DWB-00319-00; for earlier revisions connect J5 to J5 and J6 to J6!)
(for Rev. C00 and later of DWB-00319-00; for earlier revisions connect J5 to J3 and J6 to J2!)
Eagle Computer X-Bus Cable Routing
Make sure to plug the X-bus cables in correctly. If the cables are not plugged in correctly, the
system will not boot or run self-test, and
the Roadrunner board could be seriously damaged!
If
your computer does not boot after doing the upgrade, turn off the system power and double check
your cable connections.