Service manual
Page 5Installation Instructions: AM-338 / AM-339 RJE Board Set
After a brief pause, you should be returned to AMOS command level and you can
proceed with the remainder of the installation. If you see the error message
?Improper SSD, verify you entered the correct PIC by re-installing the software and
trying again. If you still receive the same error, check with your dealer to make sure the
correct PIC was supplied for your computer. You must successfully complete this
portion of the AlphaRJE installation for any other portion to work.
4.4Configuring RJE for the AM-1600
In order to run AlphaRJE, you need to run two other programs prior to using RJE to
communicate with the IBM computer. The CONFIG program allows you to change
various options and the CACOTA program generates a carriage control tape file for
report formatting on IBM hosts that use carriage control.
The CONFIG program is the same as in previous versions of AlphaRJE; only now the
I/O address field will accept full 32 bit values. When you run CONFIG, use the following
values for the I/O address field:
If your AM-338 board is in J14, use FFFFFCC1.
If your AM-338 board is in J15, use FFFFFC81.
The interrupt level does not matter and may be any value from zero to seven.
5.0EAGLE AM-338/339 INSTALLATION
In order to use the RJE AM-338/339 board set in an Eagle computer, the following items
must be true:
The AM-172 board used in Eagle computers must have a H00 (or later)
boot PROM.
The AM-174 board used in Eagle computers must have a E00 (or later)
boot PROM.
The AM-319(-10) board used in Eagle 200 computers must be at revision
A01 or later.
The AM-319(-00) board used in Eagle 300, 400, and 500 computers must
be at revision C02 or later for C revision artwork and B08 or later for B
revision artwork.
All Eagle 100 computers are AM-338/399 compatible.
The Eagle computer’s operating system can be no earlier than PR8/94
AMOS 1.4C or AMOS 2.2C.
PDI-00338-00, Rev. A02