Service manual
Page 4 Installation Instructions: AM-338 / AM-339 RJE Board Set
A simple diagnostic to verify the operation of the AM-339 board is to use
an an oscilloscope to watch the DTR line (pin 20 on the DB-25 connector).
After a reset, DTR will go low for around two seconds while the AM-339
performs a memory self test. After memory self test has completed, DTR
will go high.
11.Once self test has passed, power the computer down again and replace
the top cover.
4.2Step by Step Installation (AM-1600 Deskside Model)
1.Power down your computer and remove the top cover.
2.Remove your computer’s top cover, following the instructions in
the
AM1600 Deskside Computer Service Manual.
3.Insert the AM-338 board into connector J14. Use J15 only if you have an
AM-366 Ethernet controller board installed in your computer.
4.To install the AM-339 board, use the instructions in Section 5.1 "Step by
Step Instructions for Eagle Computers." Perform all the instuctions in steps
1 through 7. After you have completed the AM-339 installation, continue
the procedure at Section 4.3.
4.3Software Installation for the AM-1600
AlphaRJE version 4.0(122) or later is required in order to use the AM-338/AM-339 board
set. Download the AlphaRJE software onto your computer’s hard disk drive; for example:
LOG OPR:
STRRES DSK0:[]=ALL:[]
No changes are required to the AM-1600’s AMOSL.INI file in order to run AlphaRJE.
Note the first time you run AlphaRJE, you will be asked to enter a Product Installation
Code (or PIC). To do so, execute the RJE program from AMOS command level. This
PIC is a unique indentifier for your computer that must be obtained from your dealer.
Enter the PIC, carefully verifying you have entered it correctly and press
RETURN
.
PDI-00338-00, Rev. A02