Service manual

Page 14 Eagle 250 Service Manual
Rev. 01
Memory Module Size
Combinations:
Total
Memory
Bank0
Settings
Bank1
Settings
124124
4MB 4MB
XXXOOO
2 x 4MB 8MB
XXXXXX
8 MB 8 MB
OXXOOO
8MB + 4MB 12MB
OXXXXX
2 x 8MB 16MB
OXXOXX
16MB 16MB
XOXOOO
16MB + 4MB 20MB
XOXXXX
16MB + 8MB 24MB
XOXOXX
2 x 16MB 32MB
XOXXOX
32MB 32MB
OOXOOO
32MB + 4MB 36MB
OOXXXX
32MB + 8MB 40MB
OOXOXX
32MB + 16MB 48MB
OOXXOX
2 x 32MB 64MB
OOXOOX
64MB 64MB
XXOOOO
64MB + 4MB 68MB
XXOXXX
64MB + 8MB 72MB
XXOOXX
64MB + 16MB 80MB
XXOXOX
64MB + 32MB 96MB
XXOOOX
2 x 64MB 128MB
XXOXXO
128MB 128MB
OXOOOO
128MB + 4MB 132MB
OXOXXX
128MB + 8MB 136MB
OXOOXX
128MB + 16MB 144MB
OXOXOX
128MB + 32MB 160MB
OXOOOX
128MB + 64MB 192MB
OXOXXO
2 x 128MB 256MB
OXOOXO
X = Jumper installed; O = Jumper not installed
Table 4: AM-138 Memory Module Jumper (JP7) Settings
INSTALLING I/O BOARDS (FULL EAGLE 250 CONFIGURATION ONLY)
I/O boards containing additional serial ports plug into the connectors at J7, J8, and J9 on the AM-138. As
discussed in the Eagle 250 Installation and Technical Manual, you should add boards starting with J7
and working up to J9. For detailed installation instructions for any serial I/O board, please refer to the