Service manual

Page 10 Eagle 250 Service Manual
Rev. 01
The SSD chip and boot
PROM on the AM-138
board require a
specialized tool for
their removal. If you
attempt to remove
the SSD chip or
boot PROM using
a screwdriver or
pocketknife, you
could easily damage
both the chip and the
socket. This type of chip
extraction tool is available
at retail stores specializing
in electronic components.
WARNING!
Figure 6: SSD Chip Removal Tools
AM-966-10 CONNECTIONS
The Eagle 250 uses the AM-966-10 front panel display board, which connects to the AM-138. In most
cases, you should not need to connect any wires to or disconnect any wires from the AM-966. However,
if any of your front panel display lights stop working, or if one or more wires come loose from the AM-
966, you can refer to the picture and list below to check and, if necessary, remake any connections.
PIN 1
J1
U3
U2
EN20
EN26
JP3
THIS JUMPER MUST
BE IN THE TOP POSITION
DWB0966-10 Rev xxx
JP6
JP1
JP5
TURBO RUN
DISK
TURBO SW
JP4
SPKR/PWR
J2
RESET
JP2
CABLE FROM AM-138
CONNECTOR P9
PLUGS IN HERE
Figure 7: AM-966-10 Board Layout