Instruction manual

Page 32 Chapter Six
Eagle 250 Upgrade Instructions, Rev. A00
8. Attach the front panel display cable. If it’s a 26-pin connector, use P9; a 20-pin connector plugs
in at P10.
If you use the 20-pin connector, you should also have four wire pairs which were connected to
the front panel from the AM-137. Attach these to the P8 connector on the AM-138-10, as
follows:
Board Label Wires Purpose/Notes
Run Yellow/White Run light; white wire goes toward
edge of board.*
Disk Red/White Disk activity light; white wire toward
edge.*
Power Green/White Power light; white wire toward edge*
Reset Green/Black Reset switch
*: If the light does not work in this orientation, reverse the wires.
FINISHING UP
The hardware portion of the upgrade is complete. Continue with Chapter 8 to test and boot the new Eagle
250. Perform these procedures before attaching the computer's cover, in case you need to make some
adjustments.
Once your system completes the testing procedures successfully, shut it off again and reattach the top
cover.