Instruction manual

Eagle 250 Upgrade Instructions, Rev. A00
Table of Contents
CHAPTER 1 -INTRODUCTION 1
ABOUT THIS DOCUMENT 1
Graphic Conventions 2
CHAPTER 2 -COMPATIBILITY 3
SOFTWARE COMPATIBILITY 3
HARDWARE COMPATIBILITY 3
SCSI TAPE AND HARD DISK DRIVE REQUIREMENTS 3
The SCSI Floppy Drive 4
SCSI Tape Drives 4
SCSI Hard Disk Drives 4
SCSI-2 Dispatcher 4
CHAPTER 3 -UPGRADING EAGLE 250 ON-BOARD MEMORY 5
ELECTRONIC EQUIPMENT HANDLING PRECAUTIONS 5
INSTALLING MEMORY 6
Setting Memory Jumpers 7
Changing Memory SIMMs 8
CHAPTER 4 -CONFIGURING THE AM-138-10 9
AM-138-10 BOARD ILLUSTRATION 9
AM-138-10 Jumpers 11
AM-138-10 Connectors 12
THE CMOS MENU 12
ETHERNET PORT 13
REMOTE RESET CAPABILITY 13
INSTALLING THE SSD CHIP 14
ON-BOARD SERIAL PORTS 14
FRONT PANEL STATUS DISPLAY CODES 15
SERIAL UPS MONITORING 15
CHAPTER 5 -BEGINNING AN EAGLE 250 UPGRADE 17
ELECTRONIC EQUIPMENT HANDLING PRECAUTIONS 17
STEP 1 - PROTECTING YOUR DATA 18
STEP 2 - INSTALL THE CORRECT VERSION OF AMOS 18
STEP 3 - UPGRADE CIRCUIT BOARDS AND PERIPHERALS 18
STEP 4 - CREATE A NEW SYSTEM MONITOR 19