Instruction manual

Page 22 Chapter Five
Eagle 250 Upgrade Instructions, Rev. A00
STEP 7 - NETWORK CONFIGURATION
In step 5, you changed a SYSTEM statement in the AM138.INI file to load the correct network interface
driver for the Eagle 250 Ethernet port you will be using. You must make the same change to the
AlphaTCP configuration file, CONFIG. To do this:
1. Log to TCP:.
2. Edit the CONFIG. File.
3. Change the IFCONFIG statement to AM138.LDV.
4. Save the file.
If the Eagle 250 won’t be using AlphaTCP, you can skip this step.
STEP 8 - PROTECT YOUR DATA AGAIN
Now that you’ve installed a new operating system, you should make a complete backup of DSK0:, and
create a new warm boot tape and/or bootable floppy disk. That way, in the unlikely event that you do
have to warm boot and restore your disk drive, you won’t have to repeat the installation of the new
operating system.
If you have an available logical disk device, you can copy DSK0: to it rather than making a
backup tape.
STEP 9 - INSTALL THE EAGLE 250 HARDWARE
The hardware installation procedure differs depending on the type of system you are upgrading from. For
specific installation instructions, please turn to the correct chapter for your upgrade:
•
Eagle 100 — Chapter 6
•
Eagle 200 or 300 — Chapter 7