Specifications

Page 5-3Installation Instructions: Roadrunner 040 EAGLE 100/AM-3000M/VME Upgrade
LOG SYS:
RETURN
WRMGEN
RETURN
Warm Boot Monitor Generator X.X(XXX)
Input monitor: AMOS32.MON
RETURN
System disk driver: SCZRR.DVR
RETURN
Number of logical units: 10
RETURN
<-- per your configuration
Bitmap size: 3969
RETURN
<-- per your configuration
Language definition table name:
RETURN
;Pressing RETURN defaults to English
SCSI dispatcher (RETURN if none): SIMRR.SYS
RETURN
System terminal interface driver: AM140.IDV
RETURN
<-- per your configuration
System terminal interface port number: 0
RETURN
System terminal interface baud rate: 19200
RETURN
<-- per your configuration
System terminal driver: AM62A.TDV
RETURN
<-- per your configuration
Enter name of SECONDARY DEVICE(s) to be defined into system,
one per line. Enter blank to terminate loading.
Device to define: TRM
RETURN
Device to define: /STR0
RETURN
Device to define:
RETURN
Enter name of program(s) to be preloaded into SYSTEM MEMORY,
one per line. Enter blank to terminate loading.
Program to load: SYSMSG.USA
RETURN
Program to load: STR.DVR[1,6]
RETURN
Program to load: CMDLIN.SYS
RETURN
Program to load: SCNWLD.SYS
RETURN
Program to load:
RETURN
Enter name of program(s) to be preloaded into USER PARTITION,
one per line. Enter blank to terminate loading.
Program to load: LOG.LIT
RETURN
Program to load: DIR.LIT
RETURN
Program to load: COPY.LIT
RETURN
Program to load: DUMP.LIT
RETURN
Program to load: MOUNT.LIT
RETURN
Program to load: MTURES.LIT
RETURN
Program to load: MTUDIR.LIT
RETURN
Program to load: FMTSCZ.LIT
RETURN
Program to load: FMTSCZ.OVR
RETURN
Program to load: DSKANA.LIT
RETURN
Program to load: DSKDDT.LIT
RETURN
Program to load: SYSACT.LIT
RETURN
Program to load:
RETURN
;after you enter this return, your
AMOS32.WRM file will be created.
Once the warm boot monitor is created you can install a tape into your tape drive and
enter: CRT620/B
RETURN
. The program will then prompt you to enter the name of the warm
boot monitor you just created (i.e. AMOS32.WRM). Or, you can enter the name of the
warm boot monitor directly on the command line: CRT620 AMOS32
RETURN
. Where the "/B"
is implied, and the default filename extension is ".WRM".
PDI-00172-60, Rev. A02