Specifications
Page 3-11Installation Instructions: Roadrunner 040 EAGLE 100/AM-3000M/VME Upgrade
3.2.4Installing the Roadrunner Board
Before you install your Roadrunner, make sure the board is properly setup for your
configuration. The previous AM-174 jumper configuration illustration explains the
function of each jumper.
Refer to the next two illustrations and the following instructions to install the Roadrunner
mounting bracket and the AM-174 Roadrunner board:
1.A bracket (DWF-20748-00) designed for mounting the Roadrunner board
is included in the installation kit. To install the bracket, you must remove
the four phillips-head screws indicated in the previous illustration (if not
already done).
2.After the screws have been removed, install the DWF-20748-00 bracket as
shown in the following illustration. The bracket is held in place with four 1.5
inch #6-32 phillips-head screws (included in the installation kit).
3.Once the mounting bracket has been secured, install the Roadrunner on
the bracket making sure it’s oriented exactly as shown in the next
illustration. The Roadrunner board is held in place with four #6-32
phillips-head screws where indicated.
PDI-00172-60, Rev. A02