Specifications

Page 2-9Installation Instructions: Roadrunner 040 EAGLE 100/AM-3000M/VME Upgrade
1.Refer to the following illustration to locate and remove the four nuts and
screws holding the fan cover plate in place.
2.After removing the screws, bend the cover plate back and forth until the
plate separates (breaks off) from I/O mounting panel.
The rear I/O panel is made of thin sheet metal and should not take much
effort to detach the adjoining fan cover plate. You may however, need a
flat blade screwdriver to pry the plate away from the chassis rear panel to
make the first bend.
MC1252
Remove the four
nuts and screws
that hold the fan
cover plate in place.
Then bend the plate
back and forth until
it breaks off from the
rear I/O panel.
Removing the Extra Fan Cover Plate
PDI-00172-60, Rev. A02