Specifications

Page 2-8 Eagle 100 Hardware Installation

NCR

ALPHA

MICROSYSTEMS

ALPHA MICROSYSTEMS AM-174

JP7

JP2 JP1

J2 J3

JP17

JP9

JP10

040

JP6

JP13JP11JP12

JP16

JP14

JP15

ADDRESS/DATA

CONTROL/STATUS

MC1256

TOP OF MOUNTING PLATE

BOTTOM OF MOUNTING PLATE

Position the AM-174 as

shown, and secure it

with six #6 phillips-

head screws.

Installing the AM-174 on the Mounting Plate

2.2.4Installing the Corner Bracket

After the Roadrunner board is installed on the mounting plate, temporarily set the

assembly aside to install the corner fastening bracket.

The corner fastening bracket fits flush on the inside of the Eagle chassis back panel and

is used to hold the Roadrunner mounting plate in place. In order to install the corner

bracket flush, you will have to remove the extra fan hole cover plate attached to the rear

I/O mounting panel. Once the cover plate is removed, the corner bracket is positioned

over the fan vent holes and the detached cover plate is re-installed over it.

The following steps explain how to remove the fan cover plate and install the corner

fastening bracket:

PDI-00172-60, Rev. A02