Specifications
Page 2-2 Eagle 100 Hardware Installation
2.2EAGLE 100 HARDWARE INSTALLATION
The following sections describe the steps required to perform the actual Roadrunner
upgrade hardware installation. You should review each section and be familiar with the
requirements prior to disassembling your working system.
If you did not order a SCSI disk drive that was pre-loaded with a Roadrunner compatible
AMOS operating system, you need to update the software on your existing drive. The
software download and configuration procedure, located in Appendix C, must be
completed before
the Roadrunner hardware is installed in your computer.
2.2.1Preparing the AM-987 Board
Prior to installing the AM-987 board, refer to the following illustration and install three
plastic standoffs on the solder side, using plastic screws from the component side. Be
sure to install the standoffs where indicated.
Also, ensure jumper W1 is installed to enable the CPU header at U14. The jumper must
be installed in the position
toward
the header at U14.
P1
P2
ALPHA
MICROSYSTEMS
AM-987
JP1
P3
U14
U14A
W1
Set W1 to enable
header at U14
Install three plastic standoffs on solder
side, using plastic screws from top
MC1243
AM-987 Preparation for Mounting
PDI-00172-60, Rev. A02