Specifications

Page 1-6 Compatibility and Board Setup
drives can be upgraded without removing the drive from the computer. To
upgrade the newer model of the 3800 see step 3.
If the firmware is not upgraded, the drive can still be used with Roadrunner
hardware as a SCSI-1 device, but only if it has firmware at revision -04:08
or later. You can use the SCSI.LIT program as explained in step 1 to
determine the firmware revision of your tape drive.
To replace the firmware PROM, you simply remove the two TORX screws
holding the drive’s top cover in place; lift off the top cover; gently pry out
the old PROM; and install the new PROM as shown in the following
illustration:
FIRMWARE PROM
LOCATION
Make sure the notch
in the chip (indicating
pin-1) points toward
the rear of the drive.
TORX SCREWS
MAC860
AM-626 Physical PROM Replacement
PDI-00172-60, Rev. A02